decrease by a factor of 예문

예문모바일

Since 1993, the error rate of automatic face-recognition systems has decreased by a factor of 272.
The forward rate k 1 was found to decrease by a factor of 4.5 going from cyclohexane to methanol.
Typically, the dose can be decreased by a factor of 10 to 100, which will significantly cut the production cost of the vaccine.
Through development of thinner plastic films, for example, the dimensions of metallized polyester film capacitors were decreased by a factor of approximately 3 to 4.
The gas-diluting ratio is then decreased by a factor of 1.4 or two ( i . e ., the concentration is increased accordingly ).
If the f-number is decreased by a factor of, the aperture diameter is increased by the same factor, and its area is increased by a factor of 2.
The gas-diluting ratio is then decreased by a factor of two ( i . e . chemical concentration is " increased " by a factor of two ).
Between 1920 and 2000, labour requirements in the industry decreased by a factor of 1, 000, from more than 3 worker-hours per tonne to just 0.003.
The reverse rate k-1 was found to increase by a factor of 53 going from cyclohexane to methanol, while the equilibrium constant K eq decreased by a factor of 140.
Moreover, in Reunion Island, for a typical building of this type, the consumption is approximately 140 kWh / m?/ year which means a decrease by a factor of 3.
Between 1920 and 2000, labor requirements in the industry decreased by a factor of 1, 000, from more than 3 man-hours per metric ton to just 0.003.
To achieve dematerialization, Factor 10 proposes that within the next generation, human energy use must decrease by a factor of 10, and resource productivity and efficiency must increase by a factor of 10.
In 1999, Johnston et al . concluded that Sgr dSph has orbited the Milky Way for at least one Gya and that during that time its mass has decreased by a factor of two or three.
While estimates of the redshifts of HDF galaxies are somewhat crude, astronomers believe that star formation was occurring at its maximum rate 8 10 billion years ago, and has decreased by a factor of about 10 since then.
As a result of these innovations, between 1920 and 2000 labor requirements in the steel industry decreased by a factor of 1, 000, from more than 3 worker-hours per tonne to just 0.003.
Since the time of the Planck era, shortly after the Big Bang, this term has decreased by a factor of around 10 ^ { 60 }, and so must have increased by a similar amount to retain the constant value of their product.
For example, if it is known that a lens DoF scale is based on a CoC of 0.035 mm, and the actual conditions require a CoC of 0.025 mm, the CoC must be decreased by a factor of; this can be accomplished by increasing the " f "-number determined from the DoF scale by the same factor, or about 1 stop, so the lens can simply be closed down 1 stop from the value indicated on the scale.